Table of Contents
Advertisement
container show failover
To display a list of failover disks assigned to an array, use the
container show failover command. You assign failover
disks to an array with the
Syntax
container show failover [{container}]
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose assigned
failover disk(s) you want to display. If you do not specify this
parameter, the command displays all arrays and their
assigned failover disk(s).
Examples
The following example shows the failover disks assigned to array 0:
AAC0>container show failover 0
Executing: container show failover 0
container Scsi C:ID:L
--------- ----------------------------------
0
0:03:0
The example shows that array 0 was assigned disks 0:03:0 and
0:04:0 as failover disks.
Related Commands
container commands:
I
container remove failover
I
container set failover
container
0:04:0
container Commands
set failover command.
(page
3-80)
(page
3-95)
3-108
Advertisement
Table of Contents
