Enclosure Set Scsiid - Adaptec AAR-2020SA Reference Manual

enclosure set scsiid

To set the SCSI device ID for a specific device slot on a specific SAF-
TE enclosure management device, use the enclosure set
scsiid command. As discussed in other chapters, a SCSI ID
consists of a SCSI channel number (for example, 0, 1, 2, 3, and so
on), SCSI device ID (0 through 15 inclusive), and SCSI device
logical unit number (0 through 7 inclusive). The enclosure set
scsiid command allows you to set the specified device slot to a
specific SCSI device ID (the middle number of a SCSI ID).
Notes
Before setting the SCSI device ID for a specific device slot on a
specific SAF-TE enclosure management device, use the
controller pause_io command. This command pauses all I/O
activity on the currently opened controller.
You cannot set the SCSI device ID for a specific device slot to a SCSI
device ID that is already in use. The command checks for SCSI
device ID conflicts and will display an appropriate error message if
you try to assign a SCSI device ID that is already in use.
Syntax
enclosure set scsiid {enclosure} {slot}
{device_id}
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device. The device slot to be assigned a SCSI channel number
is located on this enclosure management device. For this
version, the controller supports a maximum of eight
enclosure management devices on each bus.
{slot}
Specifies the unit number associated with the device slot that
you want to assign a SCSI channel number. This integer can
range from 0 to 15 inclusive.
{device_id}
Specifies the ID (0 through 15 inclusive) of the SCSI device
you want to assign to the specified device slot.
enclosure Commands
9-21