Adaptec AAR-2020SA Reference Manual page 56

As the command executes, note that the title bar of the MS-DOS
window displays the status of the command. For example:
Stat:OK!Task:101,Func:R5S Ctr:0,State:RUN 84.6%
For further details on status information, see
On UNIX systems, the message displayed after you execute the
container create raid5 command includes the root special
file associated with the newly created RAID 5 array.
Use the container list command after using the
create raid5
array.
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0 RAID-5 30.0MB
The following list describes the columns that contain information
as a result of creating a RAID 5 array with the container
create raid5 command:
I The Num Label column displays the ID number of the newly
created RAID 5 array, which in the example is 0.
If you specify a label when creating the RAID 5 array, it
appears in this column. Because no label was specified when
the RAID 5 array was created, no label appears in the column.
On UNIX systems, the root special file associated with the
RAID 5 array also appears in this column.
I
The Type column displays RAID-5 to indicate that the newly
created array is a RAID 5 array.
I
The Total Size column displays the total size of the freespace
available. In this example, 40.0 MB of freespace was specified,
which means that this column displays 30.0 MB as available.
I The Stripe Size column displays the stripe size you specified as
the stripe_size parameter, which in the example is 64 KB.
command to display information about the RAID 5
Total Oth Stripe
Size Ctr Size
64KB
page
Scsi
Usage C:ID:L Offset:Size
None 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
0:04:0 64.0KB:
container Commands
1-13.
container
Partition
10.0MB
10.0MB
10.0MB
10.0MB
3-25