Table of Contents
Advertisement
container remove failover
To remove one or more failover disks that were assigned to an
array using the container set failover command, use the
container remove failover command.
Syntax
container remove failover {container}
{scsi_device} [{scsi_device}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose assigned
failover disk(s) you want to remove.
{scsi_device}
Specifies the ID for the SCSI device that you want to remove
as a failover disk for the array specified in the container
parameter. You previously assigned this SCSI device as a
failover disk with the
For further details, see
{scsi_device}...
Specifies the ID(s) for any other SCSI device(s) you want to
remove as failover disk(s) for the array specified in the
container
Examples
Before removing one or more failover disks from an array, use the
container show failover command to obtain information
about any existing failover disks assigned to arrays.
As the following example shows, there is an array 0 that has two
failover disks assigned to it on this controller:
AAC0>container show failover
Executing: container show failover
container Scsi C:ID:L
--------- ----------------------------------
0
0:03:0
The following example removes SCSI device 0:03:0 as an assigned
failover disk for array 0:
AAC0>container remove failover 0 (0,3,0)
Executing: container remove failover 0 (CHANNEL=0,ID=3,LUN=0)
container set failover
scsi_device on page
parameter.
0:04:0
container Commands
command.
1-10.
3-80
Advertisement
Table of Contents
