Table of Contents
Advertisement
container show cache
To display the current cache parameters associated with a specific
array, use the container show cache command. Typically, you
use this command after setting cache parameters for a specific
array using the container set cache command.
Syntax
container show cache {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose
associated cache parameters you want to display.
Examples
Before setting cache parameters for a specific array, use the
container list command to obtain information about any
existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with no file system on it (as evidenced by None
displayed in the Usage column). Assume the cache parameters for
this array were previously set with the
command:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Volume 15.0MB
The following example displays cache parameters for array 0:
AAC0>container show cache 0
Executing: container show cache 0
Global container Read Cache Size
Global container Write Cache Size : 1970176
Read Cache Setting
Write Cache Setting
Write Cache Status
Total
Oth Stripe
Size
Ctr Size
: ENABLED
: ENABLED
: ENABLED
container set cache
Scsi
Usage
C:ID:L Offset:Size
None
0:02:0 64.0KB:
: 5345280
container Commands
Partition
15.0MB
3-103
Advertisement
Table of Contents
