Table of Contents
Advertisement
{container}...
Specifies the ID number or numbers (0 to 63) of one or more
arrays from which you want to create the multilevel stripe set.
You can use up to 16 arrays to create a multilevel stripe set.
All specified arrays must be the same size as the first
container
Switches
/stripe_size{=integer}
Note: This keyword does not support RAID 50 arrays
because RAID 50 arrays support only a stripe size of
64 KB.
Specifies the stripe size for the multilevel stripe set. Valid
values are 16 KB, 32 KB, and 64 KB.
If you do not specify the switch, it defaults to 64 KB.
/label{=string}
Specifies a label to be assigned to the newly created
multilevel stripe set. You can specify a maximum of sixteen
characters for the label.
If you do not specify the switch, it defaults to no label. If you
do not specify a label, you can do so later by using the
container set label command.
Examples
Before creating a multilevel stripe set, use the container list
command to obtain information about any existing arrays.
As the following example shows, there are two existing arrays
(mirror sets) on this controller at the time the multilevel stripe set is
created. These mirror sets were previously created with the
container create mirror command.
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Mirror 15MB
1
Mirror 15MB
parameter and separated by blank spaces.
Total
Oth Stripe
Size
Ctr Size
Scsi
Usage
C:ID:L Offset:Size
None
0:02:0 64.0KB:
0:02:0 15.0MB:
None
0:03:0 64.0KB:
0:03:0 15.0MB:
container Commands
Partition
15.0MB
15.0MB
15.0MB
15.0MB
3-13
Advertisement
Table of Contents
