Emerson Epsilon Eb Series Reference Manual page 181

Epsilon Eb and E Series EN Drives Reference Manual
E
N E Series Only
According to UL requirements, the E Series drive is suitable for use on a circuit capable
of delivering not more than 5000 RMS symmetrical amperes, 240 volts maximum.
Top View
Figure 100: E Series AC Power Wiring Diagram
Front View
Figure 101: Epsilon AC Power Wiring Diagram
Caution
Do not connect or disconnect AC power by inserting or removing the AC power
connector. Using the connector in this manner, even once, will damage the connector
making it unusable.
164
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Wire crimp ferrules are recommended:
If 14 AWG, use panduit #PV14-P47.
If 12 AWG, use Panduit #PV10-P55.
L1
L2
L3
GND
J1
Tighten screws
to 5 lb-in.
GND
Tighten screws
to 5 lb-in.
J1
50/60 Hz
90-264 VAC
Note: L3 is used with the E -214 only.
N
When cycling power make sure AC power is
off for 5 seconds minimum before reapplying
power.
L1
50/60 Hz
L2
90-264 VAC