Error Messages - Emerson Epsilon Eb Series Reference Manual

Epsilon Eb and E Series EN Drives Reference Manual
Figure 76: View Motor Parameters Window
The View Motor Parameters window is accessed by selecting View Motor Parameters from
the Tools menu.

Error Messages

PowerTools will pop-up an error message box to alert you to any errors it encounters. These
message boxes will describe the error and offer a possible solution.
The table below list the of common problems you might encounter when working with
PowerTools software along with the error message displayed, the most likely cause and
solution.
Problem/Message
Time-out while waiting for device response.
The attempted operation has been cancelled.
(see fault: No device selected)
The attached device(s) do not have valid
revisions, or do not have matching revisions.
Unable to communicate with device [Address
x]
The specified drive type (name) does not
match the actual drive type (name). Please
make necessary corrections.
Non-EMERSON device attached (address).
When trying to program more than one drive,
only EMC drives of the same type can be
attached to the network.
You have changed a parameter which will
not take affect until the drive has been
rebooted. Before you reboot the drive, you
will need to save your setup to NVM. Do you
wish to save your setup to drive NVM now?
(Operation Name) The attempted operation
has been cancelled.
Invalid entry. The entry exceeds the precision
allowed by this field. The finest resolution
this field accepts is (value).
The device was disconnected during the
upload. The upload was not complete.
The device was disconnected during the
download. The download was not complete.
122
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Cause
Loss of serial communications.
Attempting to broadcast to drive without
matching firmware revisions.
The device that you are attempting to
communicate with is no longer available.
The drive type you selected in the "Drive
Type" list box does not match the drive you
are downloading to.
This error is caused When you attempting to
perform an upload or download to multiple
drives and one or more of the drives are not
the same type.
See message.
Communication error.
Entered a value out of range.
Connection to the device was lost (a time-out
occurred).
Connection to the device was lost (a time-out
occurred).
Solution
Check the serial connection to the device and
try operation again.
Program each drive individually.
Check all connections and verify that you are
using the correct baud rate then try again.
Change the drive type selected in the "Drive
Type" list box to match the drive you are
downloading to.
Disconnect the device(s) that has been
specified and try the operation again or
program each device individually.
Yes/No.
Retry operation. Check connection to drive.
Enter a value within the range of that field.
The status bar displays information on the
currently selected object or action.
Check the connection to the device and try
again.
Check the connection to the device and try
again.