Emerson Epsilon Eb Series Reference Manual page 170

AC Line Filters
The AC line filters used during EMERSON Motion Control's compliance testing are listed
below. These filters are capable of supplying the drive input power to the specified drive
under maximum output power conditions.
Epsilon
Eb-202, Eb-203
Eb-205
Alternately, EMERSON Motion Control has also seen good results with the following line
filters:
Drive
EN-204
Eb-205, EN-208
Eb-202, Eb-203, Eb-205
Eb-202
AC Line Filter Installation Notes
• EMC criteria can be met in installations where multiple drives are supplied through a
single filter, however, it is the installers responsibility to verify EMC compliance.
Questions on this subject should be directed to the filter manufacturer.
• It is critical that you keep the filter inputs routed away from any electrical noise sources
to prevent noise from being induced into them and carried out of the enclosure.
Cable to Enclosure Shielding
Shielded motor, feedback, serial communications and external encoder cables were used for
EMERSON Motion Control's compliance testing and are necessary to meet the EMC
requirements. Each cable shield was grounded at the enclosure wall by the type of grommet
described earlier and shown in the figure 90.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
E Series Schaffner Part #
FN2070-10/06
EN-204 FS5278-16/08
EN-208 FS5278-16/08
EN-214 FN-258/16
Part #
Schaffner FN 2070M-16/8
Corcom 20EQ1
Schaffner FN 2070M-16/8
Corcom 20EQ1
Corcom 20EQ1
Schaffner FN 2070-6-06
Installation
EMERSON Part # Rating
960307-01 10A, 240V, 1 Ø
960305-01
16A, 240V, 1 Ø
960305-01
960304-01 16A, 480V, 3 Ø
Rating
20A, 240V, 1 Ø
6A, 240V, 1 Ø
153