Program List And Explanations; Messages; Diagnostics - Swann AMI Phosphate-II Operator's Manual

AMI Phosphate-II

Program List and Explanations

9.

1 Messages

1.1 Pending Errors
1.1.5
1.2 Maintenance List
1.2.5
1.3 Message List
1.3.1

2 Diagnostics

2.1 Identification
2.1.3
2.1.4
2.1.5
2.2 Sensors
2.2.1
2.2.1.4
2.2.1.4.1
66
Program List and Explanations
Provides the list of active errors with their status (active, acknowl-
edged). If an active error is acknowledged, the alarm relay is active
again. Cleared errors are moved to the Message list.
Indicates necessary maintenance, e.g. preparing new reagents.
Shows the error history: Error code, date / time of issue and status
(active, acknowledged, cleared). 65 errors are memorized. Then the
oldest error is cleared to save the newest error (circular buffer).
In diagnostics mode, the values can only be viewed, not modified.
Designation: View the designation of instrument.
Version: Firmware of instrument (e.g. V6.20 – 05/18)
Peripherals: PeriClip: Firmware of peristaltic pump (e.g. 1.03)
Factory Test: Test date of the Instrument, motherboard and
frontend.
Operating Time: Years / Days / Hours / Minutes / Seconds
FOME Sensor:
Current value: Shows the actual photometer signal in ppm.
Raw value: Shows the actual photometer signal in Hz.
Absorbance: Process value, depends on sample.
Cal. History: Review diagnostic values of the last calibrations.
Number: Calibration counter
Date, Time: Date and time of calibration
Slope: Slope photometer: 0.8–1.2
A-96.250.641 / 290121