Swann AMI Phosphate-II Operator's Manual page 57

AMI Phosphate-II
Troubleshooting
Error Description
E019
FOME not connected
E020 FOME dirty
E022
Reagent empty
E023 Cleaning Solution
E024 Input active
E026
IC LM75
E028 Signal output open
E030 EEprom Frontend
E031
Calibration Recout
E032 Wrong Frontend
E049
Power-on
E050 Power-down
E065 Reagents low
E067 Cleaning Solution
A-96.250.641 / 290121
Corrective action
– shut off power
– check wiring
– clean photometer, see
Photometer, p. 45
– refill reagents, see
p. 38
– refill Cleaning Solution
– See If Fault Yes is programmed in Menu
p. 79
– Hardware failure, call service
– Check wiring on signal outputs 1 and 2
– Hardware failure, call service
– Hardware failure, call service
– Hardware failure, call service
– none, normal status
– none, normal status
The decreasing number next to the triangle
in the upper status line on the display, indicates
the remaining reagent in percent. Refill reagent
on time, see Refill or replace Reagents, p. 38
Only AMI Phosphate II with Cleaning Module. A
triangle without number
cleaning solution containers are empty.
– Refill cleaning solution
Cleaning the
Refill or replace Reagents,
indicates that the
5.3.4,
57