Manitowoc Grove 5540F Service Manual page 246

TRANSMISSION AND TORQUE CONVERTER
41. Assemble pressure maintenance valve spool 41 and
spring into adaptor block. Apply Loctite 242 to plug, fit
and tighten. Do not overtighten as damage to the
aluminium housing could result.
a387980
42. Install new O-rings around ports on mating face of
solenoid valve 42. Mount solenoid valve onto pressure
maintenance valve, ensuring that port P1 aligns with
metering orifice in the pressure maintenance valve body.
Apply Loctite 242 to capscrews and tighten to 3.7 lb ft (5
Nm).
43. Fit the 4-wheel drive solenoid valve. Fit the hydraulic
pipe 43a.
7-46
a388260
44. If the gear lever turret assembly has been dismantled,
apply grease liberally to the working surfaces before
assembling. Assembly is the reverse of the procedure
detailed in Gearbox - Dismantling, Step 11, but note the
FIGURE 7-65
following:
a.
b. After fitting spring C, rotate it so that the end of the
a397010
Published 10-21-2010, Control# 198-04
5540F/YB5515 SERVICE MANUAL
Be sure to locate the slots in the levers A
(Figure 7-67) with the pegs B in the housing E.
bottom coil butts with the spigot D in the housing E.
FIGURE 7-66
FIGURE 7-67