Fdd Installation; Figure 3-3: Fdd Retention Screws - Acnodes PC 5150 User Manual

Step 3: Attach the HDD bracket to the HDD. To do this, align the four retention screw
holes in both side of HDD bracket with the retention screw holes on the side of
the HDD. Insert four retention screws into the bracket on both sides of the HDD.
Step 4: Install the HDD into the PC 5150by aligning the retention screw holes in the
base of the HDD bracket with the retention screw holes on the elevated
platform. Insert the four retention screws into the base of the HDD bracket.
Step 5: Connect the IDE/SATA cable from the IDE/SATA connector on the motherboard
to the rear of HDD.

3.6.2 FDD Installation

To install the FDD, please follow the steps below:
Step 1: The FDD bracket is attached to the elevated platform by two retention screws.
(see Figure 3-3) Remove the two retention screws from the elevated platform
and the chassis. Remove the FDD bracket by sliding toward the HDD.

Figure 3-3: FDD Retention Screws

Step 2: Attach the FDD adapter to the FDD by aligning the two retention screw holes in
the FDD adapter with the retention screw holes on the rear side of the FDD
bracket. Insert two retention screws into the adapter. (See Figure 3-4) Connect
the FDD adapter and FDD with the twisted cable.
PC 5150 Flat Panel PC
49