Cf Card Setup (Jp12); Clear Cmos Setup (Jp1); Figure 3-1: Back Cover Retention Screws; Table 3-2: Cf Card Setup Jumper Settings - Acnodes PC 5150 User Manual

Figure 3-1: Back Cover Retention Screws

3.5.2 CF Card Setup (JP12)

The CF Card Setup jumper configures a CF card as either the slave or the master.
JP12 DESCRIPTION
Open Slave (Default)
Close Master

Table 3-2: CF Card Setup Jumper Settings

3.5.3 Clear CMOS Setup (JP1)

If the motherboard fails to boot due to improper BIOS settings, use this jumper to clear the
CMOS data and reset the system BIOS information. To do this, use the jumper cap to
close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.
If the "CMOS Settings Wrong" message displays during the boot up process, try to correct
the fault by pressing the F1 to enter the CMOS Setup menu.
following:
Enter the correct CMOS setting
„
44
PC 5150 Flat Panel PC
Then do one of the
ACNODES ® Corp.