Acnodes PC 2150 User Manual

All-in-one 15.0” super slim panel pc
Hide thumbs Also See for PC 2150:

Advertisement

Quick Links

PC 2150
All-in-One
15.0" Super Slim
PANEL PC
User's Manual
Table of Contents
i

Advertisement

Table of Contents
loading

Summary of Contents for Acnodes PC 2150

  • Page 1 PC 2150 All-in-One 15.0” Super Slim PANEL PC User’s Manual Table of Contents...
  • Page 2 ACNODES assumes no responsibility for any inaccuracies that may be contained in this document. ACNODES makes no commitment to update or to keep current the information contained in this manual.
  • Page 3: Safety Approvals

    CE Marking FCC Class A FCC Compliance This equipment has been tested and complies with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 4: Safety Precautions

    Before getting started, read the following important cautions. 1. The PC 2150 does not come equipped with an operating system. An operating system must be loaded first before installing any software into the computer. 2. Be sure to ground yourself to prevent static charge when installing the internal components.
  • Page 5 Trademarks Acknowledgments ACNODES is a trademark of AXIOMTEK Co., Ltd. IBM, PC/AT, PS/2, VGA are trademarks of International Business Machines Corporation. Intel and Pentium are trademarks of Intel Corporation. MS-DOS, Microsoft C and QuickBASIC are trademarks of Microsoft Corporation.
  • Page 7: General Description

    POI terminal, stand-alone KIOSK, medical instrument, mobile communication device and banking system - to name just a few. Designed by the Industrial PC experts, the PC 2150 is virtually the ultimate one-step solution for your space-limited applications. Introduction...
  • Page 8: Specifications

    PC 2150 15.0” All-in-One PANEL PC User’s Manual Specifications 1.2.1 Core System for PC 2150 SBC83675-based system CPU: Intel Celeron 533MHz ~ 1.3G MHz; Intel Pentium III 550 ~ 1.4G MHz VIA Cyrix-III/C3 Family at 100/133MHz FSB System Chipset: VIA VT8606(Twist-T) + VT82C686B...
  • Page 9 PC 2150 15.0” All-in-One PANEL PC User’s Manual Audio: - AC-97 Codec - 32-bit Sound Blaster and sound Pro compatible - 16-bit stereo ADC and DAC - PC97/PC98 and WHQL specifications - Full-duplex operation for simultaneous record and playback - Internal MIC-in, Line-in, Speaker/Line-out interface...
  • Page 10 PC 2150 15.0” All-in-One PANEL PC User’s Manual 1.2.4 System Specification 15.0” TFT with 1024 x 768 resolution NEMA 4/12 sealed front panel 24X slim type CD-ROM drive (Optional) Slim floppy disk drive Heat dispensing design Two free slots for PCI/ISA and ISA expansion, or two free slots for PCI/ISA and PCI expansion −...
  • Page 11 PC 2150 15.0” All-in-One PANEL PC User’s Manual Dimensions The following diagrams show the dimensions and outlines of PC 2150. Introduction...
  • Page 12 PC 2150 15.0” All-in-One PANEL PC User’s Manual Introduction...
  • Page 13 PC 2150 15.0” All-in-One PANEL PC User’s Manual I/O Outlets The following figure shows the I/O locations of the PC 2150. Most of the I/O connectors are located on the back panel of the PC 2150. CD-ROM Slim FDD Power Switch AC inlet USB v1.1...
  • Page 14: Utilities Supported

    PC 2150 15.0” All-in-One PANEL PC User’s Manual Utilities Supported Watchdog Utility Ethernet Utility VGA Drivers Touch screen Utility Introduction...
  • Page 15: System Configuration

    PC 2150 15.0” All-in-One PANEL PC User’s Manual System Configuration This chapter details the system parts and components with figures. Sections include System Major Parts System Configuration 2.1.1 Front View The figure below shows the features and controls on the PC 2150 front panel.
  • Page 16: Panel Mount

    PC 2150 15.0" All-in-One PANEL PC User’s Manual Panel Mount The PC 2150 is mainly designed for panel mount application. To mount the PC 2150, the standard set of mounting kit (included in the system packaging) is needed. Please refer to the following figure.
  • Page 17: System Installation

    PS/2 Mouse Parallel Port The PC 2150 has a Pentium III little board with a free ISA and PCI slots inside the riser card assembly. It already builds in a Pentium III CPU, relevant DRAM and a 3.5” HDD (or Dual 2.5” optional HDD).
  • Page 18: Cpu, Hdd, And Dram Installation

    PC 2150 15.0” All-in-One PANEL PC User’s Manual CPU, HDD, and DRAM Installation The standard PC 2150 system was designed Pentium III / Celeron level CPUs, and a 3.5” (or Dual 2.5”) hard disk drives. The build-in CPU board, SBC83675, provides one 168-pin DIMM socket that supports system memory up to 512MB.
  • Page 19 PC 2150 15.0” All-in-One PANEL PC User’s Manual 1. Remove the 3 screws securing the riser card assembly’s back cover. Take off the cover by sliding it outward and pulling it upwards as pointed by the arrows. If your system does not come with a riser card assembly, proceed to step 2.
  • Page 20: Fdd Installation

    PC 2150 15.0” All-in-One PANEL PC User’s Manual FDD Installation When upgrading the CD-ROM or FDD, refer to the following illustration and instructions: 1. Remove the 3 screws securing the riser card assembly’s back cover. Take off the cover by sliding it outward and pulling it upwards as pointed by the arrows.
  • Page 21 PC 2150 15.0” All-in-One PANEL PC User’s Manual System Installation...
  • Page 22: Cd-Rom Installation

    PC 2150 15.0” All-in-One PANEL PC User’s Manual CD-ROM Installation In order to reduce the unnecessary cost burden for the customer, ACNODES offers the CD-ROM Kit as an optional accessory. Customer can install the CD-ROM by themselves with the following simple steps.
  • Page 23 PC 2150 15.0” All-in-One PANEL PC User’s Manual Another 6 screws, located on the upper perimeter (3) and lower half (3), needs to be removed. These screws are the screws bolting the system’s rear cover to the main unit. You may now take off the system’s rear cover (along with the riser card assembly).
  • Page 24: X Serial Ports

    PC 2150 15.0” All-in-One PANEL PC User’s Manual 3 x Serial Ports The PC 2150 provides four onboard serial ports installed on the back bottom side of the chassis. For systems, COM1 and COM2 are RS-232 and COM4 is RS-232/422/485. Each serial port is with...
  • Page 25: Parallel Port

    The printer interface is a 25-pin D-SUB connector. To connect any parallel device, just plug in the device connector to the 25-pin D-SUB. The PC 2150 has an analog RGB interface connector. It is able to connect to an expansion CRT monitor, and the system can display on both the flat panel and the CRT simultaneously.
  • Page 26 PC 2150 15.0” All-in-One PANEL PC User’s Manual Digital I/Os The PC 2150 provides a digital I/O of 4-channel inputs/outputs for simple automation control. For example, it can be used to control the opening and closing of the cash drawer on a POS system. It can also be used for UPS control.
  • Page 27: Riser Card Assembly

    PC 2150 15.0” All-in-One PANEL PC User’s Manual Riser Card Assembly The PC 2150 can be equipped with an optional riser card for PCI or ISA slots expansion. There are 2 riser card options available for PC 2150, 1PCI/2ISA or 2PCI/2ISA.
  • Page 28 6. Slide the riser card assembly’s rear cover back into place. Screw the lid back to the main section by fastening 3 more screws located on top of the cover. 3.10 PS/2 Mouse The PC 2150 has one PS/2 mouse connector. A simple plug-in will make the connection. System Installation...
  • Page 29: System O/S And Software Installation

    PC 2150 15.0” All-in-One PANEL PC User’s Manual 3.11 System O/S and Software Installation The PC 2150 is compatible with varieties of mainstream operating systems. Users can choose to install the OS in the 3.5” , 2.5” HDD or Solid State Disk (Compact Flash.) software such as WinCE.net, Embedded XP, and Embedded Linux...
  • Page 30 PC 2150 15.0” All-in-One PANEL PC User’s Manual This page does not contain any information. System Installation...
  • Page 31 PC 2150 15.0” All-in-One PANEL PC User’s Manual System Installation...
  • Page 32: Power Supply Specifications

    PC 2150 15.0” All-in-One PANEL PC User’s Manual Power Supply Specifications The power supply used in the PC 2150 is a 100W open frame power supply. The specifications and features of this special power supply are listed in the following sections.
  • Page 33 PC 2150 15.0” All-in-One PANEL PC User’s Manual A.1.3 General Specifications Efficiency: 80% typ. A.1.4 Environmental Specifications Operating temperature range: 0°C to 50°C Storage temperature range: -40°C to +85°C Humidity, non-condensing: A.1.5 International Standards Safety Standards Designed to meet the following standards: UL 60950, CSA 22.2 NO.
  • Page 34: Optional Dc Power Supplies

    PC 2150 15.0” All-in-One PANEL PC User’s Manual A.2 Optional DC Power Supplies A.2.1 +18~56V 100W DC Power Supply Input Specifications Input voltage range: Input current: 8A @ +18V Input protection: FUSE, 12A/125V. Output Specifications Load Range: MODEL NO. INPUT VOLTAGE MIN.LOAD...
  • Page 35 PC 2150 15.0” All-in-One PANEL PC User’s Manual Short circuit protection: When output short to ground, the power supply will shutdown and auto recovery when fault condition has been removed. Over load protection: When output power over 115% to 180% of 100W, the power supply will shutdown and auto recovery when fault condition has been removed.
  • Page 36 PC 2150 15.0” All-in-One PANEL PC User’s Manual A.3 ATX 100W Power Supply This Power Supply is a triple output 110 watts power supply. A.3.1 Output Specifications Load Range Output Min. load Rated load +12V -12V 3.3V +5Vsb 0.75A Total output power The maximum combined output power on the 3.3V and 5V...
  • Page 37 PC 2150 15.0” All-in-One PANEL PC User’s Manual A.3.3 General Specifications Efficiency: higher than 70% typ. A.3.4 Environmental Specifications Operating temperature range: 0°C to 50°C Storage temperature range: -20°C to +70°C Humidity, non-condensing: Altitude: 0 to 10000ft, A.3.5 International Standards...

Table of Contents