with the currently installed 15" TFT LCD screen. Change this jumper setting
may cause damage to the system.
The LCD Voltage Setup jumper sets the voltage for the LCD screen. This setting MUST
NOT be changed.
JP2
1-2 closed
3-4 closed
5-6 closed
Table 3-15: LCD Voltage Setup Jumper Settings
3.6 HDD, FDD and CD Drive Installation
3.6.1 HDD Installation
To install the HDD, please follow the steps below:
Step 1: Remove the back cover. See Section 3.5.1 above.
Step 2: The HDD bracket is attached to the elevated platform by four retention screws.
Remove the four retention screws from the elevated platform. (See Figure 3-2)
Figure 3-2: HDD Retention Screws
48
DESCRIPTION
+3.3V (default)
+5V
+12V
PC 5150 Flat Panel PC
ACNODES ® Corp.