Figure 3-14: Cut The Panel - Acnodes PC 5150 User Manual

Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions of
the PC 5150. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the PC 5150but just large enough
for the rear panel of the PC 5150to fit through (see Figure
3-14).

Figure 3-14: Cut the Panel

Step 3: Slide the PC 5150through the hole until the metal frame is flush against the
panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the PC 5150, behind the metal frame. Refer to the mounting kit packing list for
the required number of mounting clamps.
PC 5150 Flat Panel PC
57