Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the PC 5150 Flat panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the
PC 5150 Flat panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
PC 5150 Flat panel PC. The PC 5150 Flat panel PC arm mount retention screw
holes are shown in Figure 3-17.
Figure 3-17: Arm Mount Retention Screw Holes
Step 4: Secure the PC 5150to the interface pad by inserting four retention screws
through the mounting arm interface pad and into the PC 5150 Flat panel PC.
3.7.4 Cabinet and Rack Installation
The PC 5150 Flat panel PC can be installed into a cabinet or rack. To do this, please
PC 5150 Flat Panel PC
59