Fdd Installation; Figure 3-3: Fdd Retention Screws - Acnodes PC 5170 User Manual

Insert the four retention screws into the base of the HDD bracket.
Connect the IDE/SATA cable from the IDE/SATA connector on the motherboard
Step 5:
to the rear of HDD.Step 0:

3.6.2 FDD Installation

To install the FDD, please follow the steps below:
Remove the back cover (Section 3.5.1).
Step 1:
The FDD bracket is attached to the elevated platform by two retention screws
Step 2:
(Figure 3-3). Remove the two retention screws from the elevated platform.
Remove the FDD bracket by sliding toward the HDD.
Step 3:

Figure 3-3: FDD Retention Screws

Attach the FDD adapter to the FDD by aligning the two retention screw holes in
Step 4:
the FDD adapter with the retention screw holes on the rear side of the FDD
bracket. Insert two retention screws into the adapter (Figure 3-4). Connect the
FDD adapter and FDD with ribbon cable.
Page 52
PC 5170 Flat Panel PC
ACNODES ® Corp.