Figure 3-4: FDD Adapter and FDD Bracket Installation
Step 3: Attach the FDD bracket to the FDD. To do this, align the four retention screw
holes in the FDD bracket with the retention screw holes on the sides of the FDD.
Insert four retention screws into the bracket of the FDD.
Step 4: Slide the FDD into the PC 5150and align the retention screw holes in the base
and top of the FDD bracket with the retention screw hole on the chassis panel
and the metal sheet. Insert the two retention screws.
Step 5: Connect the FDD ribbon cable and the power cable from the connectors on the
motherboard and the PSU to the rear of the FDD.
3.6.3 CD Drive Installation
To install the CD drive, please follow the steps below:
Step 1: Attach a CD drive adapter to a CD drive by aligning the two retention screw
holes in the CD drive adapter with the retention screw holes on the rear side of
the CD drive.
Step 2: Place two spacers between the CD drive and CD drive adapter.
Step 3: Insert two retention screws and secure the adapter to the CD drive (Figure 3-5)
50
PC 5150 Flat Panel PC
ACNODES ® Corp.