Detaching The Elevated Platform; Figure 4-1: Rear Cover Retention Screws (Real Panel) - Acnodes PC 5150 User Manual

easily damaged by electrostatic discharge (ESD). Before working with the
internal components make sure all the anti-static precautions described
earlier have been observed.
To access the panel PC internal components, the back cover must be removed. To
remove the back cover, please follow the steps below.
Step 1: Remove the PC 5150 from its mount (panel, wall, rack, arm, etc.).
Step 2: The back cover is secured to the chassis with nine retention screws, eight on the
rear panel and one on the bottom panel. (See Figure 4-1) Remove the nine
retention screws and lift the cover off the PC 5150.

Figure 4-1: Rear Cover Retention Screws (Real Panel)

4.3.2 Detaching the Elevated Platform

To replace PSU module, the back cover of the PC 5150must be removed and the
elevated platform must be detached. Back cover removal is discussed above (see
Section 4.3.1). To detach the elevated platform, please follow the steps below.
Step 1: The elevated platform is located on the right side of the PC 5150and
PC 5150 Flat Panel PC
65