FP PostBase Vision Reference Manual page 34

34
PostBase Vision
Connection on the franking machine
Connecting the feeder
Caution! If the feeder was previously in a
cold environment (i.e. below 10 °C / 50 °F):
Wait at least two hours after unpacking before
connecting the feeder. The feeder needs this
time to adapt to the environmental conditions.
• Connect the feeder connection cable to the
Power connection • Plug the power cable into the power con-
• Only then plug the power cable into the
CAN-BUS interface of the franking
machine. Screw the connector on tightly.
nection for the feeder.
power outlet.