Adjust Moistening Level - FP PostBase Vision Reference Manual

18.9.2

Adjust moistening level

With the help of the supplied spacer ring, the moistening level can be adapted to the
letters accordingly. Depending on the position of the spacer ring, moistening of the
envelope flaps can be reduced or increased.
Warning! Electrical hazards due to short circuits.
Be extremely careful when handling the sealant tank and tray to prevent spilling
any fluids. Make sure not to dampen any parts connected to electronics. If this
should happen, immediately pull the power plugs. Have the PostBase Vision
franking system checked by the Customer Support before using it again.
Spacer ring
• Switch the franking system off.
• Remove sealant tank out of the housing
3 seconds
At the rear of feeder:
• Carefully pull the sealant tray out to the
Normal moistening
Lug
With this setting, you achieve best results in
most cases.
• Position the spacer ring so that the teeth
(for further information see chapter 18.9.1
on page 144).
back (see page 149).
are facing down and the lug on the tray is
placed between the guides. The teeth have
to nip into the cut-outs of the tray.
Maintenance and care
147