Cleaning / Changing The Moistening Sponge - FP PostBase Vision Reference Manual

148
PostBase Vision
Spacer ring
18.9.3

Cleaning / changing the moistening sponge

The sponge for moistening the envelope flaps should be cleaned regularly. Check the
condition of the sponge and replace it if exhausted. We recommend always keeping
a new sponge in reserve.
Warning! Electrical hazards due to short circuits.
Be extremely careful when handling the sealant tank and tray to prevent spilling
any fluids. Make sure not to dampen any parts connected to electronics. If this
should happen, immediately pull the power plugs. Have the PostBase Vision
franking system checked by the Customer Support before using it again.
Increased moistening
Lug
• Position the spacer ring so that the teeth
• Insert the sealant tray into the housing until
• Insert sealant tank into the housing with the
• Switch the franking system off.
3 seconds
are facing up and the lug on the tray is
placed between the guides.
it clicks into place (see page 150).
cover downward. Close the flap. (See
page 146.)