Correcting The Moistening Felt Position On The Rocker (Sealer) - FP PostBase Vision Reference Manual

174
PostBase Vision
19.5 Correcting the moistening felt position on the rocker
(Sealer)
Hold leg spring
in place!
Moistening felt correctly
positioned:
Projection 1 - 2 mm
Rocker with moistening felt
Moistening felt
Aligned with
stop edge
• Slightly tilt the rocker and pull it off in an
obliquely upward direction.
Caution! Always hold the leg spring on the
pin with one hand while positioning the mois-
tening felt. This will prevent the leg spring
from jamming or jumping out.
• Push the long moistening felt side fully
underneath the clamping strip such that
– the felt's recesses are perfectly aligned
with the rocker stop edge and
– both moistening felt outer edges uni-
formly project over the rocker edge by
approximately 1 - 2 mm. See illustration.
• Carefully displace the moistening felt in the
clamping strip if necessary.
• Reattach the rocker on the sealer
(see page 158).