FP PostBase Vision Reference Manual page 168

168
PostBase Vision
Issue
...
during installation / commissioning
Delivery is incomplete /
damaged.
Blank display.
Error when establishing
a connection.
Error during installation
procedure.
Possible cause and remedy
Do not start operating the PostBase Vision frank-
ing system. Contact Customer Service.
Check whether the power cable is plugged in cor-
rectly and that PostBase Vision is turned on.
Connection to the FP infrastructure not possible
with the current connectivity settings.
Repeat the network configuration with S
You will find an overview on setting the network
parameters on page 121.
Ethernet cable (network cable) for the LAN con-
nection not connected / not connected correctly.
Check cable connections (see page 25).
Internet access of the network / router disrupted.
Contact the network administrator.
FP Infrastructure currently not accessible.
Try again later.
An error message with troubleshooting information
appears.
If necessary:
• Turn off PostBase Vision (see page 38).
• Wait one minute.
• Turn PostBase Vision on again.
The installation procedure restarts.
Note: Make sure the connection configuration is
correct.
.
ETTINGS