Quick Start; Identification - Siemens SITRANS P Operating Instructions Manual

Parameter assignment
9.3 Parameter assignment over remote operation
9.3.2

Quick start

You use the "Quick start" wizard to configure your device in five steps for the required
application:
● Step 1: Identification
● Step 2: Application
● Step 3: Scaling
Note that you set the displayed pressure unit with the "Pressure units" (Page 107)
parameter and not with the wizard.
Set the unit of the selected application (e.g. volume, mass flow) also via the parameter
group "Settings > Current output > Scaling > Unit".
● Step 4: Fault current
● Step 5: Summary
The summary provides an overview of the "old" and "new" parameters.
To store the parameters in SIMATIC PDM and transfer them to the device, click the "Apply"
button.
9.3.3

Identification

Define the data that you need to identify your device under the "Identification" parameter group.
A distinction is made between data you can set yourself and values that are preset in the
factory.
The default values are write-protected and cannot be changed. The corresponding allocation
is set out in the following example:
Parameter
Tag
Long tag (TAG)
Description
Message
Installation date
Device
Manufacturer
Product name
Article number
Order option 1/ Order option 2
Serial number
Final assembly number
Hardware version
Firmware version
EDD version
146
Adjustable Preset Factory setting
X -
X -
X -
X -
X -
- X Siemens
- X SITRANS P420
- X e.g. 7MF0440-1GL01-5AF2-Z
- X e.g. A01+C11+C12+C14+C20+E00+H01+Y01+Y15+Y21
- X In accordance with the measuring cell selection/device manufac‐
ture
X -
- X In accordance with the measuring cell selection/device manufac‐
ture
- X In accordance with the measuring cell selection/device manufac‐
ture
- X
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC