Siemens SITRANS P Operating Instructions Manual page 79

Parame‐ Parameter name on
ter ID the display
06 SQRT POINT
07 ZERO POINT
08 APPLY LRV
09 APPLY URV
10 FAULT CURR
11 LO FAULT CUR
12 UP FAULT CUR
13 SATURAT LOW
14 SATURAT HIGH
15 SV SELECT
16 LEVEL UNITS
16 VOL UNITS
16 VFLOW UNITS
16 MFLOW UNITS
17 TEMP UNITS
18 LOWER SCALNG
19 UPPER SCALNG
20 LOW FLOW CUT
21 VESSEL DIM A
22 VESSEL DIM L
23 BUTTON LOCK
24 CHANGE PIN
25 RECOVERY ID
26 PIN RECOVERY
27 USER PIN
28 DEVICE MODE
29 FUNCT SAFETY
30 DISPLAY TEST
31 LOOP TEST
32 START VIEW
33 PRESSURE REF
34 IDENTIFY
35 RESET
36 OVERLD BEHAV
1) The "Application" parameter is also called the "Transfer function" in certain configuration
tools.
Hereinafter, the parameter ID is always written inside parentheses after the parameter name.
Example: Parameter "Damping value" [04].
See also
Parameter assignment over device with display (Page 106)
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
Meaning
Application point for volume flow and mass flow (VSLN and MSLIN) (Page 119)
Zero point adjustment (Page 119)
Apply lower range value (with pressure applied) (Page 122)
Apply upper range value (with pressure applied) (Page 122)
Select fault current (Page 124)
Lower fault current (Page 124)
Upper fault current (Page 125)
Lower saturation limit (Page 125)
Upper saturation limit (Page 126)
SV selection, set secondary variable (Page 127)
Level unit (Page 127)
Volume units (Page 127)
Volume flow units (Page 127)
Mass flow units (Page 127)
Temperature units for sensor and electronics temperature (Page 130)
Lower scaling point (Page 130)
Upper scaling point (Page 132)
Low flow cut-off for volume flow and mass flow (VSOFF and MSOFF) (Page 132)
Vessel dimension A (Page 133)
Vessel dimension L (Page 134)
Enable and disable button lock (Page 134)
Change user PIN (Page 135)
Display Recovery ID (Page 136)
PIN recovery (Page 137)
Enable and disable user PIN (Page 138)
Active device mode (Page 140)
Enable and disable Functional Safety (Page 140)
Display test (Page 141)
Loop test (Page 141)
Start view (Page 142)
Pressure reference (Page 143)
Identify the device (Page 143)
Reset (Page 143)
Overload behavior (Page 145)
7.2 Operating the device with display
Operating
79