Operating The Device With Display; Navigating In The Views; Measurement View - Siemens SITRANS P Operating Instructions Manual

Operating

7.2 Operating the device with display

7.2 Operating the device with display
7.2.1

Navigating in the views

You navigate in the views with the Buttons (Page 75) buttons:
Views
Measurement view After the initialization, the measurement view is displayed.
Parameter view
Edit view
7.2.2

Measurement view

The measurement view shows the current measured values as well as status and diagnostic
messages:
①
②
③
④
Figure 7-2
①
shows the name of the measured value and the set unit as alternating values.
Measured value IDs
76
Buttons
1. Select a random measured value with the buttons
2. Change to the parameter view with the
3. Return to the measurement view with the
The "EDIT" symbol has been activated permanently.
1. Select a parameter with the buttons
2. Change to the edit view with the button
3. Return to the measurement view with the
The "EDIT" symbol flashes.
1. Change the parameter value with the
2. Save the change with the button
You are in the parameter view.
3. Return to the measurement view with the
If you do not change any parameters, you return from the edit view to the param‐
eter view with the
Name and unit of the measured value (alternating)
Measured value
Measured value ID
Bar display
Example of measurement view
③
start with "P".
button.
or
.
or
.
button.
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
or .
button.
.
button.
button.
button.