Changing Parameter Values; Symbols For Information Messages; Remote Operation - Siemens SITRANS P Operating Instructions Manual

7.2.4.1

Changing parameter values

Requirement
The button lock is disabled.
Disabling button lock (Page 135)
Procedure
1. Navigate to the parameter view (Page 76).
2. Select the desired parameter with the
Use the
You are in the edit view.
3. Change the parameter value with the
To navigate faster, keep the
4. Save the change with the
Or, cancel the change with the
7.2.5

Symbols for information messages

The following symbols are shown on the display.
Display symbol
EDIT
SIL
Co
INFO
7.3

Remote operation

You can operate the device using HART communication. The following is required for this
purpose:
● A handheld (e.g. FC475) or PC software such as SIMATIC PDM.
● A HART modem to connect a PC with the device or a lead to connect the handheld with the
device.
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
button to confirm.
Description
● 'EDIT' is permanently enabled in the parameter view. You can read the
parameter.
● 'EDIT' flashes in the edit view. You can change the parameter.
L Device is write-protected by a jumper.
LL Button lock of device is enabled
LP Parameters and device functions are write-protected with a user PIN.
Functional Safety is enabled
The output current is constant (e.g. for loop test).
The ID next to the INFO symbol is used for identification of the diagnostic message.
or button.
or button.
or button pressed.
button.
button.
Operating
7.3 Remote operation
81