Commissioning The Device Without Display - Siemens SITRANS P Operating Instructions Manual

Procedure
Switch on the supply voltage.
● Product name and firmware version appear briefly on the display.
● The measured values are shown on the display.
For a device without a display, you read off the current output as follows:
– Over the remote control (e.g. SIMATIC PDM).
– With a DC current measuring device.
8.3

Commissioning the device without display

Introduction
In this section, you will learn how to commission the device step-by-step.
Before you start, please read the following safety information:
● General safety information (Page 19)
● Basic safety information: Installing/mounting
● Basic safety information: Connecting
● Basic safety information: Commissioning
Read the entire device manual in order to achieve the optimum performance of the device.
Procedure
1. Mount the device.
Installing (Page 47)
Installation (level) (Page 51)
2. Connect the device.
Connecting the device (Page 68)
3. Switch on the supply voltage.
Switching on the supply voltage (Page 88)
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
8.3 Commissioning the device without display
Commissioning
89