Parameter assignment
9.2 Parameter assignment over device with display
Functional Safety
The following additional functionality is available for devices with Functional Safety:
Functional Safety
Enable and disable Functional Safety
Set the overload behavior
9.2
Parameter assignment over device with display
Introduction
This section describes all parameters that you can reach over the device with a display.
You will find information on operating the device with display in the section Operating the device
with display (Page 76).
You can find the list of available parameters with ID and parameter name in the section List of
parameters on the display (Page 78).
9.2.1
Pressure units [01]
With the "Pressure units" [01] parameter, you select the unit of the "Pressure" (P1) measured
value that is displayed in the measurement view.
You can find a description of the pressure units that you can set in the section Display of the
pressure units (Page 107).
With the "Pressure reference" parameter [33], you adapt the display of the pressure units to
your application, if necessary (absolute pressure or gauge pressure).
Both parameters are available using a local operation or over the remote operation.
Example
Pressure units
106
SIMATIC PDM
Menu command "De‐
vice > Functional Safe‐
ty"
"Setup > Functional
Safety > Overload be‐
havior" parameter
group
①
and Pressure reference
Device with display (lo‐
cal operation)
Functional Safety [29]
(Page 140)
Overload behavior [36]
(Page 145)
②
(alternating)
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
Device without display
(local operation)
-
-