User Pin [27] - Siemens SITRANS P Operating Instructions Manual

Parameter assignment
9.2 Parameter assignment over device with display
Procedure
1. In the parameter view, select the "PIN recovery" parameter.
2. Press the
The cursor and the "EDIT" symbol flash.
3. Enter the digits of the PUK:
– Use the
– Use the
– Use the
The complete PUK is shown on the top line of the display.
4. When the PUK is complete, use the
Result
● If you have entered the correct PUK, the message "NEW PIN - 2457" appears.
The user PIN has been reset to the factory setting 2457.
● If the PUK was not correctly entered, the message "FAILD" appears.
Then repeat the described procedure.
9.2.25

User PIN [27]

Used to enable or disable the user PIN.
Setting range:
Factory setting:
When the user PIN is enabled, the measured values and parameters are read-only.
● To change the parameters and use the device functions, the user PIN must be input.
138
button.
or button to change.
button to confirm.
button to delete.
ON
OFF
User PIN disabled
button to confirm.
Enable user PIN
Disable user PIN
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC