Parameter assignment
9.2 Parameter assignment over device with display
Procedure
1. Navigate to the parameter view.
Navigating in the views (Page 76)
2. Select the "Pressure units" parameter [01].
3. Press the
4. Select the desired unit with the
The pressure measurement is converted to the new pressure unit.
5. Use the
6. Navigate to the "Pressure reference" parameter [33].
7. Press the
8. Select the specific pressure unit for your application (absolute pressure, gauge pressure,
none) with the
Result
● The selected pressure unit and pressure reference are displayed as alternating values in the
measurement view.
● If the converted pressure measurement has more than 5 digits, "#####" appears in the
measurement view: Adjust the unit so that a lower value is displayed, e.g. bar instead of
mbar.
9.2.2
Set lower range value [02]/Set upper range value [03]
9.2.2.1
Set lower range value parameter [02]
Sets the lower range value without applied pressure.
Setting range:
Factory setting:
9.2.2.2
Set upper range value parameter [03]
Sets the upper range value without applied pressure.
Setting range:
Factory setting:
108
button.
button to confirm.
button.
or
button.
Within the measuring limits
0 bar, or as specified in order
Within the measuring limits
Upper measuring range limit, or as specified in order
or
button.
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC