Parameter Assignment Over Device With Display; Pressure Units [01] - Siemens SITRANS Series Operating Instructions Manual

Reset
Restore ordered configuration
Factory reset
Reset to sensor calibration
Functional Safety
The following additional functionality is available for devices with Functional Safety:
Functional Safety
Enable and disable Functional Safety
9.2

Parameter assignment over device with display

Introduction
This section describes all parameters that you can reach over the device with a display.
You will find information on operating the device with display in the section Operating the device
with display (Page 70).
You can find the list of available parameters with ID and parameter name in the section List
of parameters on the display (Page 74).
9.2.1

Pressure units [01]

Introduction
With the "Pressure units" [01] parameter, you select the unit of the "Pressure" (P1) measured
value that is displayed in the measurement view.
You can find a description of the pressure units that you can set in the section Display of the
pressure units (Page 102).
With the "Pressure reference" parameter [33], you adapt the display of the pressure units to
your application, if necessary (absolute pressure or gauge pressure).
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA
9.2 Parameter assignment over device with display
SIMATIC PDM Device with display (lo‐
cal operation)
Menu command "De‐ Restore ordered con‐
vice > Reset > Restore figuration (Page 141)
ordered configuration"
Menu command "De‐ Restore factory set‐
vice > Reset > Factory tings (Page 141)
reset"
Menu command "De‐ Reset to sensor cali‐
vice > Reset > Reset to bration (Page 140)
sensor calibration"
SIMATIC PDM Device with display (lo‐
cal operation)
Menu command "De‐ Functional Safety [29]
vice > Functional Safe‐ (Page 136)
ty"
Parameter assignment
Device without display
(local operation)
-
-
-
Device without display
(local operation)
-
101