Commissioning The Device With Display - Siemens 7MF03 Series Compact Operating Instructions

Getting started

1.2 Commissioning the device with display

4. Open the cover of the buttons:
Figure 1-1
5. Operate the buttons as follows:
Further functions are available via remote operation (e.g. SIMATIC PDM).
1.2 Commissioning the device with display
Introduction
In this section, you will learn how to commission the device step-by-step.
Before you start, please read the following safety information:
● General safety information (Page 19)
● Basic safety information: Installing/mounting (Page 23)
● Basic safety information: Connecting (Page 37)
● Basic safety information: Commissioning (Page 45)
Read the entire device manual in order to achieve the optimum performance of the device.
8
Top view
Apply lower range value (with pressure applied) Hold down the button
Apply upper range value (with pressure applied) Hold down the button
Zero point adjustment
Set Upper fault current
Set Lower fault current
Hold down the buttons
Hold down the button
Hold down the button
SITRANS P320/P420 with 4 to 20 mA/HART
Compact Operating Instructions, 09/2018, A5E38874562-AB
for 3 seconds.
for 3 seconds.
and for 3 seconds.
for 3 seconds.
for 3 seconds.