Illustration 58: Intilion - Interface For Entering The Serial Numbers - INTILION scalebloc 0.5C Operating Manual

Illustration 58: INTILION – interface for entering the serial numbers
The serial number for the scalebloc should already be entered – if this is not the case, it
can be found on the type plate. Nine serial numbers for the modules also need to be
entered for each scalebloc. The serial numbers are located at the top right-hand side on
the front of the modules.
The left and right arrows next to "scalebloc 0" can be used to switch between the different
scaleblocs. "scalebloc 0" is the "Master" here. For n scaleblocs, n x 9 serial numbers will
need to be entered.
Clicking on the Play icon adopts and saves all of the entered serial numbers. These are
then automatically imported into the "Actual" column.
The "Cloud component ID" and other values other than the "serial numbers"
described above do not need to be entered.
92
6 Commissioning
6.3 Settings in the web visualisation
INTILION GmbH