5 Installation
5.7 Inserting the lithium-ion batteries
5.7
Inserting the lithium-ion batteries
Panels are pre-installed on the system prior to delivery. The panels are secured with two
screws. The panels must be removed before inserting the lithium-ion batteries.
•
Remove the screws and remove the panels.
•
Place the panels to one side for subsequent working steps.
•
Take care not to contaminate the panels.
•
Make sure that the assembly area is free from trip hazards.
WARNING
CAUTION
INTILION scalebloc 0.5C
Risk of injury
There is a risk of crushing and collision when inserting the lithium-ion
batteries.
•
Wear the necessary personal protective equipment (PPE_
(protective work clothing, protective gloves, safety boots and a
safety helmet).
•
Observe the documentation from the supplier.
Risk of injury due to incorrect lifting and insertion of the lithium-ion
batteries
Incorrect lifting and insertion of the lithium-ion batteries leads to ergonomic
hazards.
Proceed as follows when lifting and carrying the lithium-ion batteries.
•
Position your body as close to the load as possible and make sure
to stand in front of the load where possible.
•
Position your feet at least hip-width apart.
•
Make sure that your feet are fully and securely in contact with the
floor.
•
Use your legs to lift the load; lift from the legs.
•
Keep your back naturally straight and avoid a hollow back
•
Avoid jerky movements.
•
Avoid twisting your spine.
•
Carry the load as close to your body as possible.
•
Carry loads at the centre of your body or split between the two
sides of your body.
•
Carry any heavy, unwieldy or bulky loads in pairs.
55