Structural Changes To The Battery Storage System - INTILION scalebloc 0.5C Operating Manual

Intended use also includes
–
Observation of all instructions in the operating manual
– Compliance with the inspection and maintenance intervals
– Use of consumables in accordance with the applicable safety regulations
– Compliance with the operating conditions
The technical specifications set out in the technical data must be complied with without
exception.
Only ever use the battery storage system as intended; otherwise, safe operation
cannot be guaranteed.
The operating company using the battery storage system and not the
manufacturer is responsible for all personal injury and property damage arising
from improper use.
2.1.1

Structural changes to the battery storage system

The design and the manufacturer acceptance are performed based on the German
Product Safety Act (ProdSG - Produktsicherheitsgesetz) No modifications, additions or
conversions may be made to the battery storage system without the prior written approval
of INTILION GmbH.
The product will lose its EU conformity in the event of non-compliance. The manufacturer
of the battery storage system is outside of the warranty and any warranty claims. This
also applies to welding work on load-bearing components.
Components not in perfect condition must be reported to the HOPPECKE Service
Competence Center immediately (see Section "1.5 Service/customer service").
Continued use of the system is not permitted.
Only use original spare parts/wear parts/accessories. These parts have been specially
designed for the battery storage system. If parts that are manufactured by third parties
are used, it cannot be guaranteed that they have been designed and produced such that
they can bear sufficient loads and comply with safety standards.
Parts and special equipment that are not supplied by INTILION GmbH are not approved
for use on the battery storage system.
14
with INTILION GmbH.
2 Safety
2.1 Intended use
INTILION GmbH