Installing The Panels For The Fire-Protection Modules; Illustration 25: Panel For The Fire-Protection Modules; Illustration 26: Panel For The Bms, Inverter, The Controlshield And The Installation Areas - INTILION scalebloc 0.5C Operating Manual

Table of Contents

5.9

Installing the panels for the fire-protection modules

Panels are installed in front of the fire-protection modules, in front of the battery

management system (BMS) and in front of the inverter.

The panels for the ControlShield and the installation areas are installed at a later

date.

The various panel types are shown below:

Panel for the fire-protection modules

Panel for the battery management system (BMS), the inverter, the ControlShield

and the installation areas

For the fire-protection modules, the panels with louvered metal sheet and Icotek

grommets are used.

For the power cable, the Icotek grommets KT13 are used; for the

communication/ventilator cables, the Icotek grommets KT8 are used.

The procedure for the installation of a panel is described below.

Installation is performed in a similar way for the other panels.

No control cable is connected to battery module 9 (see Section 5.8). In order to

subsequently seal the fire-protection module, there is a dummy grommet (Icotek

grommet with no hole) for the unoccupied recess in the panel. This grommet is

included with the delivery of the INTILION scalebloc.

•

Place the Icotek grommets KT13 or KT8 around the corresponding cables.

5.9 Installing the panels for the fire-protection modules

5 Installation

INTILION GmbH

Table of Contents