Routing The Cable On The Weight Tower - Precor Discovery Selectorized Series Assembly Manual

Routing the Cable on the Weight Tower

The weight tower ships with the kick cover and pulley cover attached.
To route the cable on the weight tower:
1. Using a ⁵ ₃₂-inch hex bit, remove the screw and pulley cover and set them
aside.
Figure 10: Kick plate pulley cover removal
Shoulder Press Assembly Guide: Routing the Cable Assembly
2. Grasp the kick cover on either side (see arrows in the following figure) and
press inward slightly so that the notches on the back of the kick cover
unlock from their mounts.
Figure 11: Kick cover removal
3. Gently lift the kick cover and set it aside.
9