Tightening All Frame Fasteners; Stabilizing The Equipment - Precor Discovery Selectorized Series Assembly Manual

Tightening All Frame Fasteners

Once you have completed assembly, make sure all loose bolts are tightened.
Use the following procedure to fully tighten the bolts that apply to the
equipment you are assembling.
Note: Begin with the bolts located on the cross support.
To tighten the equipment fasteners:
1. Tighten the cross support bolts to 500 in-lb (56 N-m) with a ⁵ ₁₆-inch hex
tip bit and a 1-inch wrench.
2. Tighten the 5-inch bolts to 250 in-lb (28 N-m) with a ⁷ ₃₂-inch hex tip bit
and a ⁹ ₁₆-inch wrench.
3. Tighten the base and cross support transition plate bolts to 500 in-lb (56
N-m) with a ⁵ ₁₆-inch hex tip bit.
Shoulder Press Assembly Guide: Assembling the Equipment

Stabilizing the Equipment

CAUTION: To prevent damage to the equipment foot, tighten it all the way
into the frame before moving the equipment.
Use the adjustable equipment foot to ensure the equipment sits level on the
floor.
Note: The equipment may have more than one adjustable foot. Use the same
instructions to stabilize equipment with multiple adjustable feet.
To adjust the equipment foot:
1. Turn the adjustable foot to the left or right until the equipment sits level on
the floor.
Figure 6: Equipment foot
2. Gently rock the equipment to ensure that it is level. If there is any
movement, readjust the foot.
6