Precor Discovery Series Assembly Manual
  1. Manuals
  2. Brands
  3. Precor Manuals
  4. Fitness Equipment
  5. Discovery Series
  6. Assembly manual

Precor Discovery Series Assembly Manual

Plate loaded squat machine
Hide thumbs Also See for Discovery Series:

Advertisement

Table of Contents

ENGLISH
Discovery™ Series Plate Loaded Squat Machine
(624) Assembly Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Discovery Series and is the answer not in the manual?

Questions and answers

Related Manuals for Precor Discovery Series

Summary of Contents for Precor Discovery Series

  • Page 1 ENGLISH Discovery™ Series Plate Loaded Squat Machine (624) Assembly Guide...

  • Page 3: Assembly Requirements

    Assembly Requirements To assemble the equipment, follow the steps in the order listed in this assembly Height guide. For more product information, visit us at www.precor.com. adjustment Long placard Shoulder frame assembly WARNING Cable arm At least two people are required to assemble the equipment.

  • Page 4: Hardware Kit

    Hardware kit Component Quantity Component Quantity Socket head cap bolt Flat head hex bolt (M12 x 70 mm) (M12 × 35 mm) Button head bolt (M10 x 25 mm) Flat washer (13 x 26 mm) black Socket head cap bolt Socket head bolt (M8 x 25 mm) (M12 ×...

  • Page 5: Begin Assembly

    Begin Assembly NOTE Fully tighten all bolts. In the center frame bracket, position the shoulder frame support pivot to DO NOT fully tighten the fasteners until instructed to do so. align the bracket and frame openings. Slide the short axle through the base Remove shoulder pad pivot supports of the shoulder frame support and attach the shoulder frame support using two bolts...
  • Page 6 Attach moving arms, shoulder frame and placards Reconnect the shoulder pad assembly back through the rod end (Figure 5). Attach moving arms: Position the weight arm pivot tube in line with the bottom holes in the rear upright bracket. Ask your assistant to hold it level while you slide the axle with the center groove through the bracket and secure it using two bolts and two washers Figure 5...
  • Page 7 Height calibration and foot plate Attach each shoulder pad using three screws and washers (Figure 8). Fully tighten the bolts. Assemble height calibration Place a bumper on either side of the height adjustment assembly bottom rod end and position it inside of the weight arm bracket (Figure 11). Figure 8 Figure 11 Attach placards...
  • Page 8 Attach Weights If the pop pin does not release in all positions, loosen the jam nut and turn the adjustment nut counter clockwise, ½ turn (Figure 13). Attach weight arm horns Then tighten the jam nut and retest. Continue this process until the pop pin releases at all heights when the Slide the weight horn through the bumper and into the weight arm (Figure load is removed from the shoulder frame.
  • Page 9 Downward To the left apprised of your local industry standards. Precor shall not be held liable for failure Continue to test the corners of the equipment and readjust the feet as to properly bolt the strength equipment to the floor.
  • Page 10 DPL Squat Machine (624) Assembly Guide P/N CW39176-112, ENU ©2019 Precor Incorporated 16 May 2019...

This manual is also suitable for:

Discovery dpl0624

Table of Contents