Table of Contents
Advertisement
Select from bank 0 to 9 (register number 1 to 99) for
the effect.
For details about bank selection, see "Bank and
register selection in the Flexi Pad control block"
(page 312).
3
Press the button for the register to be recalled.
The selected button lights orange, and this recalls the
master timeline. The selected bank and register
number are displayed on the top right button in the
memory recall section.
4
Execute the effect.
Pressing the [REWIND] button in the memory recall
section moves to the first keyframe of the effect.
Pressing the [RUN] button executes the effect.
If a pause is set in the effect, the display of the [RUN]
button will switch to [PAUSE] at the pause point.
When you press the [PAUSE] button, the display
returns to [RUN] and effect execution resumes.
Editing Registers
Using the Effect menu, you can carry out the following
effect register operations.
• Effect status display (see page 304)
• Effect attribute settings (see page 304)
• Effect register editing (see page 305)
This section describes the menu for effect registers 1 to 99
as an example.
Carry out similar operations in the Effect 101-199 menu,
Effect 201-299 menu, and Effect 301-399 menu for user
programmable DME registers.
Carry out similar operations in the DEV/PBUS Effect 1-
250 menu for P-Bus and Device1 to Device12 registers.
Effect Status Display
The Effect >Effect 1-99 menu displays the following
information.
Region name: The selected region name appears in the
upper part of the list.
Register number
Register name
Write-protected status: When the register is write-
protected, an "L" appears.
Empty status: When the register is empty, an "E" appears.
Effect Attribute Settings
Applying effect dissolve
Apply the "effect dissolve" attribute to a keyframe effect.
1
Open the Effect >Effect 1-99 >Attribute menu (6221).
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
3
Press [OK].
4
Select a register.
To select all registers, press [ALL]. To select multiple
registers, set the [Num] parameter.
304
Advertisement
Table of Contents
