Configuring Settings To Use The Software - Sony XVS Series User Manual

4
Press [Set].
The selection is reflected in the "Install" field and
"Title" field in the upper list.
5
Press [Install].
"On" appears in the "Install" field to indicate it is cued
for installation. To cancel this installation setting,
press [Install] again, making the field blank.
6
Repeat steps 3 to 5 to confirm all software to be
installed.
7
Press [Execute].
8
Check the message, then press [Yes].
The installation starts.
When completed successfully, "OK" appears in the
"Install" field.
Configuring Settings to Use the
Software
An install key must be entered to enable the software in
order to use the following software options (entry of the
install key is not required if the software is installed at the
factory).
For details about entering the install key, contact your
Sony representative.
To obtain an install key, you may be required to submit the
unique device ID of the device you are using.
You can check the unique device ID in the Engineering
Setup >System >Install/Unit Config menu (7316).
Software Name
XZS-8200 Multi Program 2 Software
XZS-8510 Switcher Upgrade Software
XZS-8520
XZS-8530
XZS-8540
XZS-8550
a) Required license for XKS-8210 Mix Effect Board (1st to 5th boards) 4K
support
To display the unique device ID
In the Engineering Setup >System >Install/Unit Config
menu (7316), select the target device to operate, and press
[License] to open the License menu (7316.6).
Device name
List of software option
numbers and product
names
Entering the install key
1
In the Engineering Setup >System >Install/Unit
Config menu (7316), select the target device to
operate.
2
Press [License].
The License menu (7316.6) appears.
3
Select the software for which you want to obtain a
license ("Condition" field is blank).
4
Press [License Management].
a)
The License Management menu (7316.7) appears.
5
Press [Activate License].
6
Enter the 16-character install key you have been given
in the keyboard window, and press [Enter].
7
Press [OK].
"Active" appears in the "Condition" field.
8
Restart the device using one of the following methods.
• In the Engineering Setup >System >Initialize menu
(7315), select the device with the registered license,
press [Reset] in the <Initialize> group, and then
press [Execute].
• Turn the power off and then on again.
369
Unique device ID
Software license state