Setting Utility/Shotbox Control Block Button Assignments; Setting Device Control Block (Trackball) Button Assignments; Setting Menu Panel Button Assignments; Inhibiting Utility 2 Bus And Key Operations - Sony XVS Series User Manual

To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Setting Utility/Shotbox Control Block
Button Assignments
You can change the assignments of the mode selection
buttons and keyframe operation buttons in the utility/
shotbox control block.
For details about memory recall button assignment, see
"Assigning a Function to a Memory Recall Button in the
Utility/Shotbox Control Block" (page 387).
1
In the Engineering Setup >Panel >Config >Link/
Program Button menu (7321.8), press [Utility/
Shotbox Module].
The Utility/Shotbox Module menu (7321.36) appears.
2
In the <Utility/Shotbox Module> group, select the
target utility/shotbox control block to set.
3
Press the target button to make an assignment.
4
In the list on the right, select the function to assign.
5
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Setting Device Control Block
(Trackball) Button Assignments
You can change the assignments of the mode selection
buttons, channel selection buttons, and operation buttons
in the device control block (trackball).
Note
The assignments of operation buttons in VTR/disk
recorder/frame memory operation mode cannot be
changed.
1
In the Engineering Setup >Panel >Config >Link/
Program Button menu (7321.8), press [Trackball
Module].
The Trackball Module menu (7321.17) appears.
2
In the <Area Select> group, select the target button to
set.
Mode/Channel: Set assignments for the mode
selection buttons and channel selection buttons.
Function: Set assignments for the operation buttons.
3
Press the target button to make an assignment.
4
In the list on the right, select the function to assign.
5
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Setting Menu Panel Button
Assignments
You can change the assignment of the top menu selection
button and user preference buttons in the menu panel.
For details about user preference button function
assignment, see "Assigning Functions to User Preference
Buttons" (page 384).
1
In the Engineering Setup >Panel >Config >Link/
Program Button menu (7321.8), press [Menu Panel].
The Menu Panel menu (7321.19) appears.
2
Press the target button to make an assignment.
3
In the list on the right, select the function to assign.
4
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Inhibiting Utility 2 Bus and Key
Operations
You can inhibit operations on the utility 2 bus and keys 1
to 8 of the M/E and PGM/PST banks in the menu.
The following control blocks can be inhibited.
• Cross-point control block
• Transition control block
• Independent key transition control block
• Key fader control block
377