Sony XVS Series User Manual page 313

This switches the memory recall section to snapshot
operation mode.
The last recalled bank is displayed on the M/E-1 bank.
2
Select the target bank for operation using the bank
selection buttons.
Select from bank 0 to 9 (register number 1 to 99) for
the snapshot.
For details about bank selection, see "Bank and
register selection in the Flexi Pad control block"
(page 312).
3
To add temporary attributes (see page 308), press the
following buttons, turning them on.
Control Temporary
block attribute
Cross- A/B bus cross-
point point hold
control
block
Key cross-point
hold
Key disable
Flexi Pad Effect dissolve
control
Auto transition
block
a) When the operation mode is set to [Xpt Hold] in the Setup menu.
b) When the operation mode is set to [Key Disable] or [Key Dsbl with
Status] in the Setup menu.
For details about operation modes, see "Setting the
operation mode of a cross-point hold button on the key
bus" (page 414).
Notes
• The cross-point hold and key disable settings are
maintained until you next press and release the
cross-point hold button.
• Adding a temporary attribute does not affect the
attribute settings saved in registers.
4
Press the button for the register to be recalled.
The selected button is lit orange, and the snapshot is
recalled.
The selected bank and register number are displayed
on the top right button in the memory recall section.
Deleting a snapshot
1
In the M/E-1 bank Flexi Pad control block, press the
[SNAPSHOT] button.
Button
[XPTHLD BKGD A] and
[XPTHLD BKGD B]
buttons of the cross-point
pad
[XPTHLD KEY1] to
[XPTHLD KEY8] buttons
a)
of the cross-point pad
[XPTHLD KEY1] to
[XPTHLD KEY8] buttons
b)
of the cross-point pad
[EFF DISS] button
[AUTO TRANS] button
313
This switches the memory recall section to snapshot
operation mode.
The last recalled bank is displayed on the M/E-1 bank.
2
Select the target bank for operation using the bank
selection buttons.
Select from bank 0 to 9 (register number 1 to 99) for
the snapshot.
For details about bank selection, see "Bank and
register selection in the Flexi Pad control block"
(page 312).
3
Press and hold the [DEL] button, and press the button
of the register in which the snapshot you want to delete
is saved.
The selected button changes to register number
display.