Table of Contents
Advertisement
Button name
Description
TRACE
When a DME channel is assigned
to another keyer, this switches to
the keyer assigned with the DME
channel (trace function).
Press and hold the [TRACE] button
and press the target DME channel
button to switch keyers.
MON (monitor)
• Assigns a DME channel output to
the monitor signal.
Press and hold the [MON] button
and press the target DME
channel selection button to set it.
• You can check the monitor signal
assignment status by pressing
the [MON] button by itself.
Lit amber:
Assignable DME channel.
Lit green:
Currently assigned DME channel.
PROC KEY
Press the [PROC KEY], turning it
(processed key)
on amber, to enable selection of a
processed key signal as a re-entry
signal (PROC V, PROC K) on a
bank (M/E-1 to M/E-5, PGM/PST).
FM FEED (frame
Pressing the [FM FEED] button,
memory feed)
turning it on amber momentarily,
selects the processed key signal on
the frame memory source 1 and 2
buses. The [PROC KEY] button is lit
amber simultaneously.
SHOW KEY
Displays the processed key source
signal on the specified output (edit
preview or image creation bank
preview) while the [SHOW KEY]
button is pressed (or for a preset
time) (show key function).
The show key function output and
preset time are configured in the
Setup menu.
For details, see "Setting Show Key"
(page 413).
AUTO DELEG (auto
Switches the key control block
delegation)
delegation selection in conjunction
with buttons on the following control
blocks.
• Transition control block: [KEY1] to
[KEY8] buttons
• Cross-point pad on the cross-
point control block: Key 1 to 8 bus
delegation buttons [KEY1] to
[KEY8]
• 1st row on cross-point control
block (key/AUX bus delegation
mode): [KEY1] to [KEY8] buttons
• Memory recall section on the
Flexi Pad control block (key
operation mode): [KEY1] to
[KEY8] buttons
• Key fader control block: Key
delegation buttons
Button name
MORE
f Display
Displays the name of parameter items and the setting
value.
g Adjustment knobs
These buttons adjust the parameters of items selected using
the setting buttons.
35
Description
• When there are more than six
parameters, this button is lit
amber.
• Press the [MORE] button, turning
it on green, to display the 6th and
subsequent parameters.
Advertisement
Table of Contents
