Table of Contents
Advertisement
No.
Parameter Adjustment
3
Hue Speed Speed at which the hue changes
Mix Color: Insert a mix color signal (see page 219) in the
afterimage portion.
Ext Video: Insert an external video signal input from Ext
In in the afterimage portion.
Rainbow: Use a freeze image with the hue changing every
frame in the afterimage portion. The difference from
[Hue Rotate] is that many colors appear
simultaneously. You can set the following parameters.
No.
Parameter Adjustment
1
Luminance Luminance
2
Saturation
Saturation
3
Hue Speed Speed at which the hue changes
Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the DME >Light/Trail >Trail menu (4152), press [Trail
Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Selecting the freeze timing
In the <Trail Freeze Timing> group of the DME >Light/
Trail >Trail menu (4152), select the timing for freezing a
trail.
Frame: Freeze in frame units.
Field: Freeze in field units.
Note
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.98, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
Defocusing the afterimage portion (Defocus)
1
In the DME >Light/Trail >Trail menu (4152), press
[Defocus], turning it on.
2
Set the following parameters.
No.
Parameter Adjustment
1
Defocus V
Degree of defocusing of the video
signal
2
Defocus K
Degree of defocusing of the key
signal
To turn the afterimage portion into stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >Trail menu (4152), press
[Dust], turning it on.
2
Set the following parameters.
No.
Parameter
1
Trail Dust
2
Dust Soft
3
Dust Size
4
Dust Aspect Aspect ratio of stardust
a) The way in which the afterimage disappears is affected by both
Decay and Trail Dust parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the
combine.
Notes
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Trail effect only
is applied, regardless of the selection in the <Combine
Process> group.
In the <Combine Process> group of the DME >Light/Trail
>Trail menu (4152), select one of the following.
Combine −> Trail: Add the Trail effect after the combine.
The trail parameter data for the channel with the
lowest number among the channels being combined is
enabled.
Trail −> Combine: Add the Trail effect before the
combine. Trails parameters can be set independently
for each channel.
Combine −> Trail
241
Adjustment
Amount of the afterimage
a)
disappearing as stardust
Timing with which stardust
disappears
Size of stardust
Trail −> Combine
Advertisement
Table of Contents
