Table of Contents
Advertisement
Macro Operations (Flexi
Pad Control Block)
MCRO button
Memory recall section
Flexi Pad control block
Banks and registers
To allow operations on the 250 registers, the Flexi Pad
control block treats the registers in groups. These groups
are called "banks." There are 26 banks, numbered 0 to 25.
For details about the correspondence between banks and
registers, see "Banks and Registers" (page 311).
Recalling a Macro Register and
Executing a Macro
A macro operation is performed by recalling a macro
register. The operation varies depending on the macro
execution mode.
Executing a macro in normal execution
mode
1
In the Flexi Pad control block, press the [MCRO]
button.
DEL button
UNDO button
Bank selection buttons
334
This switches the memory recall section to macro
operation mode.
The last recalled bank is displayed.
2
Use the bank selection buttons to select the target bank
for operation.
Select from bank 0 to 25 (register number 1 to 250).
For details about bank selection, see "Bank and
register selection in the Flexi Pad control block"
(page 312).
3
Press the button for the target register.
The macro register is recalled, and the macro is
executed. During macro execution, the selected button
blinks orange.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of executed events and total number of
events are displayed on the center button in the bottom
row.
Notes
• It is not possible to execute more than one macro at a
time.
• If the same register is recalled again during macro
execution or when the macro is paused, the following
operation depends on a setting in the Setup menu.
For details, see "Setting the Macro Execution Mode"
(page 395).
• Individual events stored in a macro are executed
according to the settings in the Setup menu. If you
change the settings in the Setup menu, a saved macro
may not have the expected effect.
• During macro execution, if you switch the control panel
to macro editing mode, the macro currently being
executed stops.
• It is not possible to execute a macro during macro
editing.
• While executing a macro, the operation performed if
another macro is recalled from the Flexi Pad control
block depends on a setting in the Setup menu.
For details, see "Setting the Macro Execution Mode"
(page 395).
When a pause event is configured
When execution of a macro is paused, the [TAKE] button
is displayed in the memory recall section.
Press the [TAKE] button to resume the macro.
Executing a macro in step execution mode
1
Recall a macro register using steps 1 to 3 in
"Executing a macro in normal execution mode"
(page 334).
Advertisement
Table of Contents
